LED panel light is a kind of LED energy-saving lamp, which is very common in family living room and office. Because of the advantages of bright and uniform lighting, large lighting area, simple and elegant appearance, and good lighting effects, it is favored by many people.

There are four main installation methods for LED panel lights: embedded installation method, hoisting installation method, concealed installation method, and surface-mounted installation method.

Embedded installation method

This method is more suitable for the installation of integrated ceilings. It is more common in offices, shops, kitchens and bathrooms, etc. It is also the most common installation method, and the steps are not complicated. First, remove a piece of the ceiling to form a light trough, put the driver of the LED panel light on the ceiling next to it, then connect the power supply, and put the panel light into the light trough to complete. The installation method is relatively simple.

Ceiling installation method

This method is more personal and not so common. The installation method is to first fix the base of the 4 hanging wires on the lighting to the roof, then connect the 4 hanging wires to the LED panel light, then connect the driving power line of the light, and then pull the steel wire to adjust the height of the panel light. This installation method is more flexible, and the height can be adjusted freely, as long as it does not cause obstruction.

Concealed installation method

This installation method is more traditional and suitable for occasions where the decoration is relatively simple. The method is to first cut out the size of the inner edge of the LED panel light frame on the ceiling with a utility knife, then install the light frame, connect the light driving power line, and finally inlay the LED panel light.

Surface-mounted installation method

This installation method is very similar to the concealed installation method above, the difference is that the outer frame of the LED light is embedded outside the ceiling and protrudes from the ceiling plane. This installation method is also the simplest, without removing a part of the ceiling, just fix the frame of the LED panel light on the ceiling first, then connect the LED drive power line, and press the panel light firmly on the fixed frame. .

Both the concealed installation method and the exposed installation method are more suitable for occasions with relatively simple decoration, and the embedded installation method is more suitable for the installation of integrated ceilings. The final effects of these three installations are actually not much different, and they are all simple and elegant styles . The hoisting installation method is more individual, suitable for those who pursue personalized decoration. But special attention should be paid to the firmness of the hanging wire, so as not to shake severely during use, affect the lighting effect, or even fall down and cause accidents. These are very bad consequences.